Easy Method for Groundwater Recharge Calculation?

More Aishik Debnath's questions See All

Why there are two peaks while using the mie plot of Silver nanoparticle?

Hi, I am trying to learn the theoretical modelling of silver nanoparticle using the Mie scattering theory. After that, I discovered a software named Mieplot developed by Philip Laven, where it...

25 February 2021 7,493 6 View

Lift off problem with Indium/Gold deposition?

Hi, I'm doing 5/40nm In/Au e-beam evaporation at rates 0.2A/s(for In),1A/s(Au) on lithographically(doubly coated 495k,950k PMMA e-beam resist) done Si substrate at base pressure 2e-6torr. I'm...

18 January 2021 7,550 4 View

How much would be the particle size difference between Malvern Zetasizer Ultra Particle Analyzer and TEM for the same Nanoparticles?

I am measuring the particle size of nanoparticles by Malvern Zetasizer Ultra Particle Analyzer but I am not sure I would get a better size with TEM or not. Because I read in a paper that there is...

05 January 2021 1,612 8 View

Why a distorted admitance value is obtained while doing mixed mode simulation of TFET with dyanamic non local BTBT model in Santaurus TCAD ?

AC analysis of TFET device along with dynamic non local BTBT model shows a distorted admitance. But while using Local BTBT model a good values for the admitance is observed.

20 July 2020 2,465 1 View

If a system is stable in each of the operating regions, can it be said that the system is stable for the entire operating region?

If an operating region is divided into a number of sectors and if it is shown that the system is stable in equilibrium point corresponding to each of the sectors, can it be said that the system is...

21 March 2020 8,816 6 View

Which is the best instrument for the Soil Erosion Measurement?

I want to measure the soil erosion of a watershed. Is there any instrument which will help me to measure the soil erosion?

24 February 2020 8,934 22 View

How to do optimization by neural network in matlab?

I have used 30 experimental data set for ANN modelling (Matlab) and RSM based optimization (Design Expert). The RSM and ANN predicted data was compared and it was observed that the ANN model has...

30 January 2020 7,760 3 View

Where we can find the World geochemical background values of these heavy metals Fe, Zn, Pb, Cr, Cu, Ni, Cd for calc of sediment indexes?

These background values/reference values can be used for calculation of different indexes, viz. enrichment factor, geo-accumulation index, contamination factor, pollution load index and many more.

22 January 2020 8,948 3 View

How to incorporate random uncertainty within the A-matrix represented by a gain block in Simulink?

I have a Simulink gain block that houses the A- matrix of the plant and I want to add randomness into the parameters of A-matrix. How do I achieve that in Simulink?

05 December 2019 6,127 7 View

How to code in Matlab Ellipse by Oblong method?

How to code in Matlab Ellipse by Oblong method? The Video link is given below- https://www.youtube.com/watch?v=TNQE9vN3QJo&t=23s

08 November 2019 3,238 1 View

Stats to compare recharge of groundwater and determine if precipitation has more of an effect on groundwater levels before or after resto??

Hello all, I am looking for ways to compare recharge of groundwater and determine if precipitation has more of an effect on groundwater levels before or after restoration? My data set contains a...

08 February 2021 7,887 5 View

What is the best geophysical machine or device for detecting groundwater?

what is the best geophysical machine or device for detecting groundwater? Are there any machine that can detect the depth and the type of water? do I have to buy one machine or more than one to...

26 January 2021 6,149 15 View

Is there any low-cost filtering system (or other tech.)to lower the salt conc. (salinity) of surface/groundwater for large scale agricultural system??

The available water (surface and groundwater) is highly saline (6-20 dS/m). It is required to produce crop (moderately saline tolerant, up to 6 dS/m). Is there any low-cost filtering system (or...

18 January 2021 5,015 3 View

Which LCIA method is most suitable for assessing the impacts of nitrate leaching in groundwater (eutrophication )?

The eutrophication of groundwater by nitrate leaching is major environmental problem in Germany, especially in areas with intensive agriculture and high N-fertilizer inputs. In addition there are...

16 January 2021 5,182 7 View

How to estimate the ground water contribution while calculating the water use efficiency of a crop?

Ground water contribution is important while estimating the water use efficiency for a crop for calculation of ET without the use of Lysimeter

22 December 2020 1,254 2 View

Can anyone kindly explain what is the best method to determine the statistical correlation between two raster maps in same pixel size?

I need a method to determine statistical correlation between two GIS based raster maps. Eg. Correlation between Soil Erosion rate map (Raster) and spatial distribution map of any groundwater...

04 December 2020 9,920 11 View

Can we assume partially saturated soil conditions during Vacuum Consolidation Method?

Normally we assume that the zone of vacuum consolidation is fully saturated. But I need to find out what effect the existing groundwater table has on effectiveness of Vacuum consolidation method....

30 November 2020 2,978 1 View

How to calculate the analytical solution for the HYDRUS-3D model simulation of water and salt movement in soil?

Suppose an agricultural field with uniform soil texture and salinization. The groundwater depth is 20 meters, assuming that the depth of the groundwater and the concentration of salts remain...

25 November 2020 2,382 4 View

How to study groundwater remediation using nano zero valent iron(nZVI) in laboratory scale pilot?

Hello researchers I am conducting research on heavy metal contaminated groundwater remediation using nZVI, a batch lab experiment using the stock solution will be done but I want to design a...

06 November 2020 9,891 4 View

How to produce ROC/AUC curve using various groundwater vulnerability method for comparative analysis?

ROC/AUC Vulnerability Groundwater Machine learning

11 October 2020 9,186 3 View

Gaathier Mahed

The Water Table Fluctuation method might be the easiest for you

Cindy Viviers

I agree with Gaathier Mahed . If you have time-series groundwater level data you can calculate the average monthly groundwater level for you aquifer and compare that to the cumulative rainfall departure (deviation from the mean) of precipitation to estimate groundwater recharge. If I recall this does however require a good idea of storativity values.

In terms of the simplest way, although less reliable, is the Chloride Mass Balance Methods.

Aishik Debnath

Gaathier Mahed Sir, can you mention to me any paper where the methodology is described thoroughly and easy to understand?

Naba Kumar Shukla

Area × specific yield × water level fluctuation is the simplest method.