E-beam resist that is high temperature stable?

Rayshan Visvanathan @Rayshan_Visvanathan

05 May 2018 0 3K Report

Is there an e-beam resist that is stable in high temperature of about 300 degree Celcius? Appreciate any guidance.

Badges
Science topic

Similar topics
Entomology
Resistance

More Rayshan Visvanathan's questions See All

How to do electron density map based on aligned x-ray diffraction?

Is there any algorithm for Patterson method or electron density map reconstruction from 2D x-ray diffraction pattern?

11 December 2017 795 0 View

How is Huygen's Principle similar to Bragg's law of diffraction?

How is Huygen's Principle similar to Bragg's law of diffraction? Huygen's principle states that the final wavefront pattern at a later time is the envelop of all the wavelets that passes through...

09 October 2017 8,030 5 View

Does anyone have references on how to calculate lattice parameter for Smectic E liquid crystal from XRD or WAXS?

Does anyone have references on how to calculate lattice parameter for Smectic E liquid crystal from peaks XRD / WAXS?

07 August 2017 2,348 2 View

Why kapton tape is used in XRD setup?

Why kapton tape is used in XRD/SAXS/WAXS setup? Is it for mechanical reason?

09 October 2015 2,878 5 View

Can perovskite exist in hexagonal disk-like shape? I am using mixed-halide MAPbI(3-X)Cl(x)

Does anyone know if a hexagonal nanaplatelet-like structure could emerge out of mixed halide perovskite? I know that perovskites have a cubic like structure in the nanoscale. I am observing flat...

04 May 2015 2,847 5 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

What is the best way to drop a plasmid?

Please address the best way to drop a plasmid. Background: I have a "bait" plasmid resistant to kanamycin and a "prey" plasmid resistant to carbenicillin. After many rounds of streaking on...

25 July 2024 2,532 3 View

AGILENT HPLC 1100 SERIES , any expert available please?

AGILENT HPLC 1100 SERIES operation assistance needed.

25 July 2024 10,045 2 View

Is it possible to do transient simulation in HFSS in presence of magnetic biasing?

I have designed magnetic material with different biasing conditions in HFSS. Now I want to give an RF AC signal and do a transient simulation in HFSS. Is it possible to do in HFSS? Please help me...

24 July 2024 9,319 5 View