how do we make holes in these kinda simulators, i mean spacing between the holes and the diameter of the holes
Kindly look into below article:Article Computational analysis of drop-on-demand drop formation
any software suggestion for modeling precipitation on sandy soil and if it is easy to use better
11 December 2018 5,739 2 View
hello dear researchers and professors i want to classify all soil slopes by mechanism for example the slopes have 10-40% density will have the failure mechanism of sliding any suggestion thanks
10 November 2018 4,614 6 View
is there any formula that we can use them to see whether our simulator is working fine and our simulated rainfall like the original rainfalls/? thank you for your time
06 July 2018 1,478 6 View
hi i wanted to model deep soil mixed columns, and i was wondering which of the Flac or ABAQUS is better software to use? and can i find some ready simulated models?
11 December 2017 8,554 3 View
how many modes do we have in slope failure triggered by rainfall
11 December 2017 4,054 5 View
what scale and dimension is recommended for modeling sandy slope in lab under rainfall thanks
10 November 2017 8,101 9 View
in slope modeling, when we can neglect the effect of grain size on the slope, i mean what is the size range
10 November 2017 5,546 1 View
no matter what kind of classification, i need all of them please
09 October 2017 6,361 3 View
06 July 2017 7,576 4 View
how to change the intensity?
06 July 2017 2,345 0 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Extreme rainfall associated with climate change is causing harm to babies in some of the most forgotten places.
01 March 2021 5,647 4 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...
28 February 2021 5,415 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
One main reason for failure of most ERP implementations is the misfit between business requirents and ERP system business process be reduced. How can the misfit between business requirents and ERP...
22 February 2021 5,709 5 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View