Want to try COP from different vendors! Is there any one in China?
Thanks!
Please see http://www.topas.com
Sergey, Thank you very much!
Dear all, Happy New Year! Laser 505nm is not @Max abs peaks of Fam, Tet, and Hex, Hex as donor seems can cover acceptors with much longer wavelength, though Hex has lower absorption@505nm than...
11 December 2018 5,309 0 View
5 and 6 Fam (or 5 and 6 Tamra) have no spectral difference, only a slightly difference in orientation when labeled onto oligonucleotide. When you run gel electrophoresis, do 5 and 6 Fam (or 5 and...
05 June 2018 3,622 2 View
Which tools can be used to generate machine codes for additive manufacturing?
02 March 2021 7,220 2 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...
15 February 2021 8,342 7 View
I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...
26 January 2021 9,620 5 View
Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...
19 January 2021 3,017 2 View
The pictures were taken in Guishan Mts in Yunnan. The fungus is ca. 10-12 cm high.
07 January 2021 6,639 10 View
Dear Research Gate Members, Nowadays, everyone is talking about the new variant of Corona virus COVID-19 and its affects are alarming throughout the world. Please, share your expert suggestions...
29 December 2020 7,555 20 View
Dear Research Gate Members, Online Education / Distance Learning and Work From Home (WFH) are the ultimate new realities for many in the world due to Pandemic Novel Corona Virus (COVID-19)...
29 December 2020 9,866 37 View
Last time I was asked about simulation software to analyze the effect of shrinkages of plastic powder materials. Currently, an additive manufacturing process is what I find suitable for my...
29 December 2020 4,615 9 View
How China is the biggest emitter of CO2 gas in the world?
25 December 2020 6,184 10 View