Do you implant the same lens type in both eyes ?

Which is the most convenient manufacturing software for Additive Manufacturing?

Which tools can be used to generate machine codes for additive manufacturing?

02 March 2021 7,220 2 View

In an eye with Tyndall, does each dot correspond to an individual cell?

When you observe the presence of Tyndall in an inflamed eye: Does each of the small floating dots correspond to an individual cell or to an aggregate of cells? Does a conventional slit lamp have...

27 February 2021 6,326 2 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

How to differentiate the economic productivity in agriculture and in manufacturing sector?

Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...

15 February 2021 8,342 7 View

Should the AUC in a concentration-time graph of a subcutaneous implant be roughly the same for poeple?

I have 2 concentration time curves of a subcut drug implant. the first group has a peak around the 50 day mark where as the second group does not. Both groups received the same implant by the same...

10 February 2021 2,305 3 View

Can I apply a relative force between two elements in Ansys workbench?

I want to apply elastic tension between 2 orthodontic mini-implants is there a way to add relative force between 2 elements or i have to specify the force vector for each implant individually ?

05 February 2021 1,299 4 View

How could I do a simulation for the energy consumption of a CNC machine?

I'm working on my dissertation and it is about how to save energy when a CNC machine goes to idle mode. (A concept model of the idle machine energy saving in industrial manufacturing...

26 January 2021 9,620 5 View

What is the best antimicrobial agent among metal oxides?

I am looking for an antimicrobial metal oxide agent for a polymeric implant and I am wondering which one is the best?

21 January 2021 7,068 5 View

How to add a single parameter in Ansys Additive Manufacturing Workbench parameter setting dialogue box?

Ansys 19.2 R2 and 2020 R1 versions of Additive Manufacturing Workbench is convenient for powder-based Additive Manufacturing processing. However, in this workbench, there is a machine parameter...

19 January 2021 3,017 2 View

Inexpensive eye tracking hardware + software solution?

Hello, I am starting a project that will require an eye tracking device. I've seen eye tracking hardware + software solutions that are $10,000+ so I am hoping to find one that is significantly...

18 January 2021 8,121 12 View

Marianne Levon Shahsuvaryan

Yes I do. In my opinion the exception is PMMA lens implanted earlier. In this case for fellow eye I prefer Acrylic IOL.

Javier F Casiraghi

Yes I do.

Sometimes, patient comes with an "old fashion IOL" in one eye, so we have to implant a different IOL in the fellow eye.

I prefer a one-piece hidrophobic acrylic IOL

Dhaval Patel

Yes..I do... It is general preference of surgeon to implant same type of IOL in the other eye too..Except there is some situation preventing to do so.