Tricalcium aluminate liberates a lot of heat during the early stages of hydration but has little strength contribution. So what are the undesirable properties?
One of the possible undesirable is that it should not reduce the bounding capability, it is the trade off between strength and bounding properties.
Dear Anand Raghavendra Rao,
Thank you very much for your answer.
Regards
Khalid
Are you with or against?
31 December 2018 5,555 0 View
What are the main important reasons for publishing in a journal? Many thanks in advance.
09 October 2018 1,886 5 View
Thank you in advance
04 May 2018 6,319 0 View
Do you agree with above-mentioned? Thank you in advance.
01 February 2018 2,027 1 View
The points are when attending a conference in the field that you are doing, what will you get?
01 February 2018 4,214 0 View
Does anyone have a version of this? Thank you in advance
01 February 2018 8,235 1 View
It's undeniable that publishing papers, especially in high impact journal, give empowering knowledge for the benefit of society. What you think about the other publications. Is it an achievement?
31 December 2017 9,961 7 View
Dear colleagues, Thank you in advance.
31 December 2017 2,569 7 View
Concrete gives its full strength through the chemical reaction between cement and water which is called hydration. What are the Strongest Types of Concrete? Dear colleagues, thank you for your...
31 December 2017 4,251 3 View
Is there any specific webside for the above objective
31 December 2017 6,493 2 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
How do you tie-break and rank these two in their strength?
03 August 2024 4,471 1 View
Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...
03 August 2024 2,546 2 View
I am using a windows system, what software I should use for hydration shell analysis with molecular dynamics?
02 August 2024 3,143 4 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,985 1 View
I would like to conduct artificial sunlight experiments to mimic heat capture and air warming in a greenhouse system. The main objective is to heat up the temperature inside the greenhouse, not...
28 July 2024 4,006 2 View