If there aren´t, could we model it somehow like an epidemic model?
Good evening everyone. If a questionnaire has 4 factors measuring different constructs as for example CAMI questionnaire measuring attitudes toward the mentally ill that has four factors:...
18 February 2021 3,223 3 View
I am trying to prepare Cerium oxide nanoparticles. literature suggested the acidic pH of the reaction. what is the reason? what is the mechanism if so
28 November 2020 8,825 2 View
Hello, I am trying to write a program in Matlab to estimate the remaining useful life of a bearing without data of a previous failure. Do you think this is possible? I was thinking to use the...
27 November 2020 9,863 3 View
Good afternoon everyone. I would like to know your oppinion or advise for the following: I would like to compare the results of a variable measured with a likert scale. I have two (or three)...
19 October 2020 4,564 4 View
Hello eveyone. I would like to know your oppinion on the following. Do you think that it is adequate to compare two groups with very different sample size and non normal sample distribution? for...
19 October 2020 8,475 4 View
Can someone suggest a simple calorimetric assay protocol for determination of total alkaloid content of plant extract?
10 September 2020 8,835 3 View
What are the environmental problems caused by phosphorus pollution ?
27 July 2020 948 34 View
15 July 2020 3,900 10 View
The importance of water resources is evident, and its management through all levels is imperative, especially in arid and semi-arid countries where water demand is highly required for irrigation...
10 July 2020 6,153 7 View
what are the advantages of using renewable energies for the desalination of seawater?
28 June 2020 6,093 3 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...
03 March 2021 4,116 4 View
The range of forms and sizes of cavities in rock is very big. Is there a classification scheme for rock cavities regarding their size and shape?
02 March 2021 4,511 3 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
