Did anyone work on the aerodynamic analysis of cricket ball while leg-spin?

13 August 2023 1 5K Report

When a leg-spin bowler throws a ball, the ball faces drag and lift force as well as Magnus effect upon it. Can you help me find any prior research work on this topic?

Vasishta Bhargava Nukala

Please refer this link

https://link.springer.com/chapter/10.1007/978-981-15-6619-6_17

It's one of the papers in which aerodynamic design of threaded seam effects the spin or trajectory of a cricket ball.

Badges
Science topic

I have a problem with sensible heat flux (H) iteration process in Sebal model?

In each iteration, I get the same value of H for different values of aerodynamic resistance and the temperature difference between two heights. Do the results make sense? Is it necessary to adjust...

07 February 2021 8,953 2 View

What reference do you recommend about doublet lattice method (DLM) coupling with finite element method (FEM) ?

I want to write a code related to the flutter of aeroelastic wing under unsteady load using doublet lattice method (DLM). I want a good reference with numerical examples or a book which learn me...

25 January 2021 7,488 3 View

How to extract the different components at a specific frequency between two spectra?

Dear everyone: Hello! Sorry that my question may take up your valuable time. Recently I have a technical problem in the data processing. We have conducted a series of wind tunnel tests in order...

18 December 2020 8,847 2 View

Cylinder drag from PIV data?

Hello, I have circular cylinder d=15 mm in diameter in flow velocity 5 m/s. The flow field was measured by PIV and the measured area is ca. 125x80 mm, perpendicular to the cylinder axis. The...

14 December 2020 8,016 4 View

How to model a real flow over a cylinder in ANSYS Fluent ?

Hello all, I am an undergrad student in Mechanical Engineering and have just started working with ANSYS Fluent. Pre-covid I was working on "Cylindrical Bluff Body Drag Reduction". I have been...

29 November 2020 8,744 4 View

If fluid and particles immersed in that fluid, are moving in the same direction, then what is the direction of drag force?

Suppose a fluid is moving in the positive x direction and a particle immersed in that fluid is also moving in the same direction as that of the fluid, then what is the direction of drag force?

23 November 2020 6,341 4 View

How can I determine the lift and drag force on a planing boat from the heave and surge forces experimentally determined by a load cell in towing tank?

The heave and surge forces on a planing boat model was measured in a towing tank. Can resolution of these forces with respect to the direction of motion of the model yield the resultant lift and...

05 October 2020 7,576 1 View

Need airfoil coordinates?

Hi all, I hope you all are doing well. I am working on the simulation of airfoils with boundary layer suction. I found a reference to validate my CFD results, as shown below. "Stanewsky E,...

06 September 2020 9,013 3 View

How can i find the drag value created by the fluid in propeller motion system?

I am trying to calculate a needed torque value to rotate a basic propeller system. The reason that i am building this is to use as a simplified version of the real system. And i am stuck at the...

26 August 2020 2,805 5 View

What drag model for simulating a fluidized bed with geldart D particles do you propose?

The minimum fluidization velocity is 1.17 m/s and the average diameter of the particles is 2.6 mm with a sphericity factor of 0.9 I am using an Eulerian-Lagrangian approach and these are the...

02 August 2020 646 2 View