i am doing a cycling stability test on my Zn|Zn symmetrical cells. The mass loading is about 5 mg/cm² and the area is 0.79 cm². i want to use the parameters of a current density 0.1 cm² and a capacity of 0.1 mAh/g. i already calculated it based on the area of my electrode, but the voltage-time profiles are not the same as in all the other papers. I am getting a voltage of 2 V instead of 2 mV. I will be very grateful if someone can explain the possible reasons for this or just provide some information on how to write the battery tester (Landt Instruments). Thank you!!
More Yog Ram's questions See All
Similar questions and discussions