Could you help me to analysis this SAED result analysis getting from a TEM analysis?

More Achmad Solikhin's questions See All

Assalam...Could you tell me what are the differences between polymer in situ, grafting into, and grafting from?

I am confused to determine these terms due to my lack knowledge in chemistry.

08 September 2017 5,456 3 View

Could cellulose crystalline region be converted mechanically into amorphous region? What is about the crystalline polymophism?

Assalam, Dear my best colleagues I face difficulties on explaining my research paper. As we know cellulose has crystalline and amorphous region, but after mechanical treatment (milling), the...

11 December 2016 1,573 0 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Does any one know how i can prepare liver tissue with transmission electron microscope with good fixation?

i have problem in preparation of liver tissue with bad cell organelles and how i can adjust osmolarity

03 March 2021 8,890 1 View

I need to image mesoporous silica nanoparticles that are in ~100 nm size and do high resolution TEM to look at mesopores. what grids should I use?

Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru

02 March 2021 1,787 2 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

Shall I skip the measurement model in SmartPLS?

Hello everyone, I had run a mediation model in SmartPLS using questionnaires that were already validated among my statistical population. A professor who edited my paper -though she is not...

01 March 2021 3,052 3 View

SEM or Multiple Regression for an analysis without Latent Variables?

Hello, I have three hypothesis to test, all with the same IV. I am testing if the effect of the IV on the first DV is mediated by awe. I am then measuring whether the effect of the IV on a...

26 February 2021 8,399 5 View

What could be the reason for not having further low chi square value (better agreement) in my refinement result?

I have tried every combination of parameter changes and after that i have a poor chi square value. I can't get it lower any further. I know there have been a lot of discussion about Rietveld...

26 February 2021 8,480 3 View

Can anyone help with Schistosoma identification?

Can anyone identify what kind of Schistosome species this might be? Morphological features of cercariae and adults resemble Trichobilharzia, though I am fairly new to the field of parasitology...

25 February 2021 7,760 6 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

Sandeep Kumar

Hi Achmad Solikhin

Please use imageJ software,

Software and tutorials are freely available

All the Best

Sandeep

https://www.google.co.in/#q=imageJ

Achmad Solikhin

Assalam

Dear Mr. Sandeep Kumar.. I downloaded the software and installed,,

However, the software can not be installed. Could you help me!

I read the instruction but it was not successful..

Please help me

Abdul Ahad

First you have to install oracle java in your operating system than you can use imageJ.

i hope it would be helpful for you.

Best regards

A. Ahad

Dheeraj Kumar

For easy and effective SAED calculations you can explore this link,

http://www.instanano.com/characterization/d-value-calculation/saed-d-value-calculation/