Conversion of a barrium salt to potassium salt?

12 December 2016 1 7K Report

Hi everybody, I want to convert a barrium salt of a chemical compound/salt to pottasium salt with K2SO4, How can I do that? Thanks in advance.

Zahra Farrokhi

Thanks very much for your response,

Kind Regards,

Zahra

Badges
Science topic

Similar topics
Chemistry
Chemicals

More Zahra Farrokhi's questions See All

I have the wrong size of plasmid after ligation, what could have happened?

I did the ligation, the vector and insert size were 5800 and 350 bp, respectively. After double digestion, the sizes were correct, I took the insert and vector from the gel and then ligation...

31 December 2015 717 13 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

In WECS : Gain values for conversion of PMSM rotor speed(rad/s) to p.u. input to wind turbine and Torque(pu) of WT to input of PMSM-Torque (Nm) ?

I am working on developing a MATLAB Simulink model of Wind turbine with PMSG followed by MPPT Boost converter. I have gone through so many literature and videos but I am not finding clear solution...

03 August 2024 888 1 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

How to remove/ replace trifluoroacetate countertop after deprotection?

After deprotection of the tert-butyl ester to generate the carboxylic acid in chloroform with TFA, my compound‘s pyridine moiety forms a TFacetate ammonium salt (small molecule drug, not a...

29 July 2024 9,753 3 View

How can one determine the conversion factor for a radiolabeled substrate to a radiolabeled product using slopes from linear regression equation?

I am preparing a radiolabeled product using a radiolabeled substrate. I have the cpm values for different dilutions of both my known substrate and unknown product ? How can one determine the...

27 July 2024 3,604 1 View

How do nutrient transporters and aquaporins interact under abiotic stress in plants?

"The Correlation between Nutrition and Transport Mechanism under Abiotic Stress in Plants: A Comprehensive Review" by Muhammad Saleem, Jianhua Zhang, Muhammad Qasim, Rashid Iqbal, and Li Song,...

23 July 2024 9,109 0 View

What does an additional peak in FTIR between 3100 and 3300 nm affect the quality of the material, benzethonium chloride USP??

I do not know much about FTIR! The material Benzethonium Chloride USP was compared to a reference standard in regards to FTIR, as per the USP testing: Identification B. Infrared absorption (FTIR),...

16 July 2024 6,918 7 View

How calculate the conversion alph from tga analysis?

I read it Convert the y-axis from mass loss to degree of conversion (100-x)%. What if tga analysis have residual char, for example at mass loss% 27% Is it the same eqation to get conversion...

15 July 2024 4,218 1 View

How to convert a potential collected with reference to Saturated calomel electrode to Reversible Hydrogen Electrode?

I have collect a LSV data by taking SCE as the reference electrode. But I want to convert this one to Potential with respect to Reversible Hydrogen Electrode. Please suggest me the required...

13 July 2024 7,841 2 View

How to change reference list (muilitple pages) from APA to Harvard?

Hello, I am looking for a tool that will do a bulk conversion of references from APA to Harvard. There are over 20 pages of references, so I would like to avoid doing them one at a time. Thank...

07 July 2024 2,003 2 View