CO2 Emission at 350°C, detected in STA/DTA-FTIR, from fast fired (roller kiln) clay ceramics?

More Sebastian Sänger's questions See All

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Paired Samples t-test or repeated measure ANOVA?

Dear Research Gate members, for my masters's thesis, I have conducted a questionnaire to investigate consumer's attitude towards sport sponsorship. I've asked three identical questions...

27 January 2021 2,910 3 View

How to ensure diversity and fight stagnation in a complex two-objective optimization problem?

I am working on solving an optimization problem with two objectives by using neuroevolution. I use NEAT to evolve solutions which need to satisfy objective A and objective B. I tried different...

27 January 2021 4,875 3 View

What is the use of Carbon and Proton NMR Spectrum in Peptide Analysis?

Am in Peptide / Protein Research, may i know what useful analytical information we are getting from 13C & 1H NMR spectroscopy analysis? Somebody getting NMR for smaller proteins, any useful...

05 January 2021 1,196 7 View

Where can I find data on the total atmospheric absorption for a standard atmosphere?

Graphs like the one attached below can be found on every website explaining the spectral properties of the atmosphere. However, I wasn't able to find the data behind these graphs. I need the...

07 December 2020 2,851 4 View

Is there some kind of Octave package (or script) available, to interact with a PEAK CAN USB (or some other CAN hardware) device?

In MATLAB, you can use the Vehicle Network Toolbox, which supports CAN interfaces. I'm searching for something similar in Octave.

06 August 2020 9,571 2 View

In Porphyrin chemistry, what are the allowed limits of deviation (In percentage) from Elemental Analysis and Mass spec?

I synthesized some (metallo) porphyrins. I am now characterizing them by Mass spec and also confirming their purity by Elemental analysis. The values I got are a little deviated from the...

26 July 2020 2,886 2 View

Can you recommend any publications or authors on "The Impact of the IT&C Sector Upon a National Economy"?

Judging by most stock markets, "Big-tech" seems to be the success story, yet there are surprisingly few academic research papers written on this phenomenon. We are looking for studies and authors...

23 July 2020 5,074 3 View

About Fortran and defining the units?

Hi to all. I am doing a large set of calculations employing as input files called 1.log, 2.log, 3.log,......, 300.log. Usually I use this definition for the input file: OPEN(5,FILE='...

12 July 2020 5,027 12 View

Submission of dna sequences to NCBI?

When i submit dna sequences to NCBI, they ask for clarification saying "Some or all of the protein coding sequences contain internal stop codons, reading frame shifts (insertions/deletions...

03 July 2020 6,101 1 View

Why does intensity drops as concentration increases?

Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?

28 February 2021 3,653 4 View

Interpretation of a fluorescence Emission spectrum ?

Hello, i work with a spectrometer which only render the fluorescence emission spectrum. Until now i just found how to interpret an exitation- and emission spectrum together to generate deeper...

20 February 2021 1,291 3 View

What is difference between In-line transmission (%) and Total transmission (%) value of optically transparent Ceramics?

I am working on transparent/translucent zirconia-based ceramics. In many papers, I have seen that they are reporting both In-line transmission (%) & Total transmission (%) value of...

20 February 2021 9,405 6 View

Receiving very less number of hits and events in acoustic emission tests?

I am doing a three point bend test with concrete specimen of dimension 280mm*90mm*90mm. I am putting 2 sensors near the notch with 3cms away from both the sides. the experiment ran for 20 mins but...

13 February 2021 2,990 1 View

For acid treated montmorillonite clays what will be the result of surface area?

The organo montmorillonite nanoclays modified with octadecylamine were used for the experiment. After acid treatment, the surface area will be increase. However, in my experiment, the surface area...

10 February 2021 1,581 3 View

Using liquids as superstrate in Fabry-Perot Cavity Antenna?

Hi, A Fabry Perot Cavity allows to increase the directivity of a low gain antenna by putting in the top of cavity a superstrate with high permittivity such as a ceramic (er=10.2). However,...

09 February 2021 6,799 8 View

How can I multiply values with standard distribution and with triangular distribution?

I am calculating emissions considering the uncertainty of the data to do Monte Carlo simulation. Some variables such as yields have normal, lognormal or even uniform distributions. These must be...

03 February 2021 6,318 5 View

Sample preparation for ceramics i.e. iron silicate (fayalite), iron oxides, alumina, spinel mineral (hercynite)?

Recommendations in preparing ceramics for nanoindentation and in the process minimize introducing stresses from sample preparation i.e. polishing stage.

02 February 2021 6,211 3 View

How do I analyse a Photoluminescence Spectrum ?

I have a few questions related to PL (images attached for same material by 2 methods), It would be great to get some help. 1. What is the physical meaning of highly intense PL? Does this mean...

02 February 2021 1,791 3 View

What should I do if the reviewer couldn't finalize the review in the journal's given time?

I have Submitted 2,3 Papers in Science Direct associated Journals but the time of the first decision has been ended so What should I do? Could I email them to remind them about the first decision?

01 February 2021 5,788 7 View

Vadim Verlotski

XRD analysis can not show carbon (carbon is too light element), so with this analysis you can only find CaO / MgO instead of CaCO3 / MgCO3.

Sebastian Sänger

We dont find any MgO/CaO in the XRD. Maybe it is thinkable that recarbonization takes place in aged / hydroxylated clay ceramics?