You can see on the curve, the Young Modulus decrease. Is there a problem with our machine or it's due to material plasticization and matrix / fiber decohesion ?
In order to have a better discussion of your results and the influence of time and temperature, I recommend to make a plot with the calculated value of each module with respect to a single variable and observe the trends, if it increases or decreases.
Revises this article, which shows the values of the modules and their tendency with respect to a single variable. (Figure 4).
This way it is easier to draw conclusions
There is no problem in the machine, the plastic property is increasing as the temperature increases.
The chart is very mixed.
It would be better to draw three separate charts.
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Materials Science
- Materials
- Composites
- Nanocomposites