Can we burn a labview (VI) code onto a raspberry pi board and let the pi do the compilation?

More Soumya Ranjan Sahoo's questions See All

Do we see connection between climate change and the transmission of coronavirus?

How likely are we to see the infectious disease spread as a result of climate change? How are the communities most at-risk, and how and why both COVID-19 and climate change harms them? Why is it...

09 February 2021 1,459 28 View

I am trying to simulate phase change of refrigerant inside pipe extracting heat from panel in comsol. Can anyone help with how to simulate this?

My model is a rectangular multi layered structure under which refrigerant flows through cylindrical pipes. A heat flux of 600W/m2 applied on panel and internal forced convection is used for...

20 January 2021 9,478 1 View

How to tackle "CONSTRAINT CONTROLS" error while using tie between CFRP and frame segment in abaqus?

Hello, I had been trying to model a portal frame wrapped with CFRP in ABAQUS. To tie the CFRP laminates with frame I need to use slave/master surface interaction. But whenever I try to model the...

19 January 2021 2,906 3 View

Why does the ghost atoms gives error in NICS calculation with wb97xd in gaussian09 ?

In a trial, I am trying to calculate NICS (0 and 1) values for benzene ring using gaussian09. I have placed the ghost atoms at the center, 1A, and 2A above the rings. On using the method/basis...

19 January 2021 3,188 3 View

What to do if I am doing a Meta Analysis of Exploratory studies and the studies do not have effect size??

I am doing a meta analysis of imaging exploratory studies which themselves did not have effect size. Therefore, I am unable to compute the variability in the effect sizes in my meta analysis. What...

18 January 2021 4,881 4 View

Rejected manuscript for journal publish after 1st revision, what needs to be done next?

Hello, My manuscript has been rejected by the editor and reviewers even after the 1st revision. Though I tend to disagree some of the points raised, assume I can't request for another revision...

28 December 2020 6,062 3 View

Acetylene reduction assay procedure?

Do anyone have the detailed step wise procedure(practical) to do the acetylene reduction assay? Or if anyone can let me know in which institute can i analyse my samples in India?

28 December 2020 6,717 2 View

How to decolonize climate change research?

Who has the right to define what is climate change research should be? Who should define the climate change research topic, research questions, and research design? Who should own the climate...

29 November 2020 1,077 12 View

Is the future of "Science" or "the Scientific Implications of Climate Change" connected with the US election?

Donald Trump and his challenger Joe Biden have presented vastly different visions for handling crucial issues, from the coronavirus pandemic to climate change. This results in how the election...

29 October 2020 8,810 6 View

Will there be effect of around 4wt % B2O3 in ladle slag on refractory erosion?

The effect of B2O3 additions on CaO-MgO-SiO2-Al2O3 based slag/flux was studied by many researchers. B2O3 addition helps in lowering the viscosity of slag which helps in eliminating the sticking of...

28 October 2020 6,722 6 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Is there a powerful system for the security of the systems distributed on IoT systems?

02 March 2021 3,858 10 View

Which is suitable for use with Python? MySQL or SQL Server?

Which is suitable for use with Python? MySQL or SQL Server? What is your suggestion?

01 March 2021 3,422 3 View

LEDs on Vis Light photo degradation of MB water sol via N doped TiO2 in a mini flume?

Good day to all, I have no experience with light emitting diodes. I am building a glass mini flume to demonstrate the photo degradation of Methylene Blue in water running over self cleaning...

26 February 2021 4,026 5 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

I am looking for a simple software program to model 3D chemical bonds. The purpose is to generate high-quality graphical abstracts. Any suggestion?

Hello everyone: I am looking for a simple software program to model chemical bonds. The purpose is to generate a high-quality graphical abstract for a top leading journal in the field of...

23 February 2021 8,012 3 View

What is the optimum time and temperature of blanching and pre-frying potato for frozen fries?

I am helping a local home industry for developing frozen fries from their local farm. I want to know what is the optimum blanching and pre-frying temperature and time for processing. Please also...

23 February 2021 1,616 5 View

How to estimate 2SLS with different instruments for different endogenous variables?

To be specific, I want to conduct an IV regression in stata with the following three equations. EQ1: Y1 ~Y2 Y3 X EQ2: Y2 ~ Z1 EQ3: Y3 ~ Z2 Both Y2 and Y3 are endogenous. However, Z1 and Z2 are...

23 February 2021 6,266 3 View

How to constrain genetic algorithm input u?

My real system (buck converter) can only take an input of 0 to 1 (duty ratio) and I need to constrain the system so the controller action keeps within this bounds. How can I do this? The code for...

22 February 2021 2,125 3 View

Soumya Ranjan Sahoo

All I need is a suitable cross compilation environment from a windows 7 (32 bit) to a debian LINUX( 32 bit) for my raspi.

Oleg Lashmanov

Short answer is no. But you can write client/server app owed re-232 or Ethernet . Labview side on PC send messages to rpi, rpi process it, and respond to PC. So for your next vi it will be lookalike rpi is yet smother vi.

Tanmay Chaturvedi

There is one interesting library I found, called LINX. It basically allows you to control Raspberry Pi through LabView running on a host machine (PC / Laptop). LINX works as an interface between Pi and LabView, so you can create VIs on a host machine and burn them on Pi and it will work accordingly.

Hope that helps.