My electrode materials shown as below,
1. MoS2
2. rGO
3. MoS2/PPy
4. rGO/PPy
5. PPy
N.B. PPy is polypyrrole. MoS2 is a graphene-like 2D material.
What I want to test:
1. CV curves
2. EIS spectra
3. Specific capacitances at various scan rates
4. Galvanostatic charge/discharge curves
5. Ragone plots (energy density against power density)
Whether I can prepared my samples on glassy carbon electrode in a three electrodes system（Pt&Ag/AgCl&Glassy carbon) and 1M KCL solution as the electrolyte.(if you can attached some relevant paper, it would be better)
Thanks
Of course, you can do. However, you may opt aqueous sodium sulphate or potassium hydroxide solution as the electrolyte, as these are used by most of the researchers. Then it will be easy for you to compare your results with others.
There are plenty of papers in this field. I'm giving few links/examples herein.
http://pubs.acs.org/doi/suppl/10.1021/acsami.6b05933/suppl_file/am6b05933_si_001.pdf
http://pubs.acs.org/doi/abs/10.1021/acssuschemeng.5b00519?journalCode=ascecg&quickLinkVolume=3&quickLinkPage=2254&selectedTab=citation&volume=3
Journal of Materials Chemistry 1(2013):12759 · August 2013
DOI: 10.1039/C3TA12736B
http://dx.doi.org/10.1016/S0378-7753(03)00606-2
http://dx.doi.org/10.1016/j.jpowsour.2012.07.073
http://dx.doi.org/10.1016/j.jpowsour.2013.02.054
- Badges
- Science topic
- Similar topics
- Engineering
- Materials Engineering