Can anyone provide a free XLstats premium link ?

More Pasha Ghazal's questions See All

What constraint can be used for rigid steel saddles and conrete beam under four point loading in ABAQUS?

Nodes are missing intersection with their respective master surface or outside the adjust zone, when using tie constraint.

01 February 2021 3,591 6 View

Why mutual inductor takes high current at no load condition?

I simulate an inductive wireless power transfer system in matlab. I set the primary and secondary mutual inductor resistance is 0.3ohm. So when i run the circuit it took high current at no load...

29 December 2020 9,536 3 View

Sterile chitosan folat polymer?

Hi, I want to start my cell culture to run a MTT assay , how can I sterilize my polymer?

15 December 2020 1,813 1 View

Solving chitosan folate nanoparticles in dmem?

Hi there, I have been struggling with solving my chitosan folate coated nanoseleniums in dmem culture media sincr it is only soluble in acetic acid , and hardly soluble in basic media. What can I do?

19 November 2020 5,636 3 View

TEM and SEM of chitosan coated nanoselenium?

Hi, I have a 25 ml sample of chitosan coated nanoselenium with average diametere of 112 nm, considering the fact that chitosan after being kept in water media swelles, how can I send a sample for...

08 November 2020 6,859 3 View

Addition of glycerol in measuring zeta potential?

Hi there I wanted to know if it is ok to add 2 or 3 drops of glycerol for suspending the nanoparticles in water before measuring the zeta potential?

26 October 2020 2,146 3 View

Chitosan coated nanoselenium ?

I'm running a MTT test for evaluation the effect of chitosan coated nanoselenium versus bare nanoseleniums, what are the controls for MTT assay? Should I test bare nanochitosans as well as...

27 September 2020 9,525 2 View

Should I do a quality assessment for studies that will be included in a systematic review, even if I am not doing meta-analysis?

The types of studies included are case reports, case series, epidemiological studies. The information collected will probably be analyzed qualitatively only.

17 August 2020 3,628 7 View

Is there a way (command or function or.....) to get the predicted value of output from fuzzy logic system, using matlab?

I want to get predicted values for output values related to some input values.

11 January 2019 7,539 4 View

How do install CFD OpenFOAM on Centos 6.4 on computer nodes (cluster)?

We are facing dependencies while installing CFD OpenFOAM software while installing it at cluster. We dont have docker? How do we manage it? Your valuable suggestions are welcome. Thanks in...

13 March 2018 1,279 3 View

Dear all, I was wondering if anyone knows whether MGLtools and Autodock can run on Mac OS?

I have tried to download the 64-bit version of MGLtools however, as many times as I have downloaded and uninstall the programs, an error arises that the app needs to be updated. Thank you.

03 March 2021 5,997 2 View

I got 02 moderator values defining Johnson-Neyman significance regions. Is it an error?

Hi everyone, I am conducting research for my Master's thesis. I am using PROCESS by Johnson-Neyman to analyze my Moderator model. I test the relationship between Public Service Motivation and...

03 March 2021 2,350 2 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Do I need to strip the PVDF membrane before staining it with colloidal gold?

Dear Colleagues, After running Western blot on PVDF membrane and detection using ECL, I would like to stain my PVDF with colloidal gold to be able to allign the ECL image with total proteins on...

02 March 2021 7,829 3 View

PACYC PCR not working after several attempts. Would anyone have any suggestions?

So, I have been trying to run a pACYC PCR which will be used later on for a Gibson Assembly. However the PCR is not working. I have already tried gradient PCR and changing extension time; however...

02 March 2021 1,146 2 View

What SPSS analysis should I run with one IV (with two levels) and two DVs?

Hi, I am trying to figure out which test would be most appropriate to run for the following question: Is there a difference in task blood pressure between smokers and non-smokers? There are two...

01 March 2021 8,235 2 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

OpenBCI eeg--has anyone used them?

I'm looking to try out an off-the-shelf EEG set for some exploratory work. Curious if anyone has used the OpenBCI, and how much set-up work is required. I've heard they are more difficult to get...

01 March 2021 4,128 3 View

Is there any expert in Smart PLS who can help me?

Dear colleagues, I have a manuscript that needs an expert in smart PLS to run the analysis, Is there anyone expert and ready to help me, please?

01 March 2021 8,212 3 View

Can I download BibExcel for MacOs?

Hi everyone, I would like to ask how I can download BibExcel software for MacOs? There are some links which are supported by Windows but I could not find it for Mac. or is there any other software...

01 March 2021 652 1 View

Ronán Michael Conroy

You are asking someone to help you to steal a copy of commercial software. This is not a good idea.

What's available in XLStats that is not available in excellent, free stats packages like jamovi or JASP?

Pasha Ghazal

I am inquiring about possibility of link share, which necessarily doesn't mean one has to steal it in order to provide link. Afterall research communities thrive by collaboration, if any one willing.

So you think it's all right to ask someone else to be dishonest?