Can anyone Explain me how to create Auxiliary channel in Arduino and Processing for 8-bit Open BCI system ?

More Niraj Bagh's questions See All

Given, ER = 0.2, WHAT WILL BE THE AIR FLOW RATE IN kg/hr?

I have a biomass with given ultimate and proximate analysis data. I am using Aspen plus for the simulation of gasification of biomass. In experimental data the gasifying agent air flow rate is...

18 June 2024 2,743 1 View

How can i solve this error in ASPEN PLUS?

i am doing a project on gasification. during pyrolysis i got the following error: * WARNING COMPONENT 'BIOMASS' IN SUBSTREAM 'NC' HAS ZERO FLOWRATE IN THE OUTLET STREAM. FRACTIONAL...

18 March 2024 6,025 1 View

How to derivatize Amino Acids using N-tert-butyldimethylsilyl- N-methyltrifluoroacetamide (MTBSTFA) for GC-MS analysis?

I recently attempted to replicate the amino acid derivatization procedure outlined by Sobolevsky et al. 2003. While I followed the steps diligently, unfortunately, I did not achieve the expected...

28 February 2024 7,101 6 View

How can i solve this error in ASPEN PLUS: COMPONENT 'DRY-BIOM' IN SUBSTREAM 'NC' HAS ZERO FLOWRATE IN THE OUTLET STREAM. FRACTIONAL CONVERSION ?

Dear all, I am doing a gasification of biomass. In the pyrolysis section i have used RSTOIC for the devolatization of the biomass. i have specified the yield from the RSTOIC. it gave me the...

19 February 2024 8,026 0 View

Welding Simulation using ABAQUS for dissimilar materials?

Hello everyone, currently m working on welding simulation of dissimilar materials in ABAQUS software. i have modeled two different plates separate for dissimilar materials. After simulating the...

01 July 2023 1,513 3 View

How to calculate hydraulic radius for the alluvial fan channels?

I am confused on calculation of the hydraulic radius for channels where the sediment bury the channel and form a convex upwards cross section. Such condition resulted in multithread braided...

26 January 2023 8,765 9 View

Goldak Heat source movement?

Dear Researchers, after running my Dflux subroutine for Goldak heat source model, my heat source is not moving further after a certain length. As i want my heat source to move from starting to...

16 October 2022 7,325 0 View

Nodal temperature in heat transfer analysis?

From my heat transfer analysis work i am not getting proper Nodal Temperature variation. Although, i have provided proper temperature depended material properties. Please share your valuable...

09 October 2022 8,482 2 View

How to decide the capacitance value for binary weighted capacitors used in the charge scaling or charge redistribution DAC in 10 bit SAR ADC ?

basic understanding of the charge scaling/charge redistribution DAC is essential

24 April 2022 4,151 0 View

Suggestions on Promoter Analysis Tool?

For the study, we have isolated a promoter sequence that has been ligated with Luciferase vector and transfected into the HeLa cells which are being incubated in different experimental conditions....

19 July 2021 5,415 3 View

Feedback defines the constitution of an organism?

“Here is a thought experiment. Let's place Rodolpho Llinas's jarred-brain on top of a body (Fig. 1). I bet Llinas would argue that his jarred-brain retains its own consciousness, and the android...

11 August 2024 2,483 1 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Simulation of metal drawing by Abaqus with UMAT?

Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...

30 July 2024 7,062 1 View

Does post-translational protein modification cause devisions on observed pI verses calculated pI?

In running two-dimensional gel electrophoresis on bacterial protein, some spots that appear to match a protein sequence have a significantly more acidic isoelectric point than the calculated pI....

24 July 2024 8,076 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Trial exclusion in eye-tracking data?

Is it reasonable to exclude all trials with a blink or saccade in the 150 ms before stimulus onset? As an alternative, would it be better to exclude blinks (after extending them by about 100 ms...

19 July 2024 3,838 0 View

What are the future implications of quantum computing on image processing algorithms?

Image Processing Algorithms, Quantum Computing.

17 July 2024 7,958 2 View

Given the current advances in Super Computation and Quantum Computing, what are the missing link between the Applied AI and Ultra Smart Cyberspace?

In recent years, quantum computing has emerged as a groundbreaking technology with the potential to revolutionize various fields, including artificial intelligence (AI). AI has already made...

17 July 2024 1,398 3 View

What are the radiometric correction procedures that are applied in Agisoft Metashape?

Dear RG-Community, I have been using Agisoft Metashape for UAV imagery processing for quite a while now. Also a while ago, I stumbled upon the Micasense GitHub repository and saw that individual...

17 July 2024 8,580 2 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

Chintan Jethva

Mr. Niraj,

You can find useful information about how to create auxiliary channel in arduino on link given below. Its kind detailed explanation so please go through the pages.

The next link gives a list of various Open BCI libraries including 8-bit and 32-bit.

Hope this will be helpful for you.

Thakyou

http://www.electronoobs.com/eng_robotica_tut5_2_1.php

https://github.com/OpenBCI?language=&page=2&q=OpenBCI&type=&utf8=%E2%9C%93

Niraj Bagh

Thank Chintan Jethva, I will go through both the links.