The temperature crossover valve is generally used in refrigeration systems. But, I want to know details of its position and significance in automobile air conditioning system. Reference patent number is: CN103968484A
11 January 2021 3,284 3 View
I need to process an image for edge detection and then want to count the number of edges in that image.
29 December 2020 5,594 2 View
I am searching to find commercial vendors who sell SWIR dyes. I could only find Nirmidas Biotech which sells different NIR-II dyes!
23 December 2020 5,002 3 View
doi of your presentation in the conference
23 December 2020 9,370 2 View
We working on PCL nano particles 1).Ketoprofen (10mg)+ dmso(5ml) Pcl (10mg)+ DCM(5ml) 2).Water 10 ml+ 10 mg When we mix both 1+2 after solublization (400 rpm) Why precipitation of polymer occurs?
09 December 2020 5,033 11 View
I want to establish DOX/R cell line in vitro for the research study.If any one suggest the protocol then it would be a great help.
03 December 2020 9,795 5 View
What is the difference between weak from Ritz method and variational form Ritz method while solving a boundary value problem ? Can all differential equations take variational form ?
18 November 2020 2,341 2 View
Hi, We are working on DAR (Drug to Antibody Ratio) estimation of ADC using the following HIC-UV method. For some of the unconjugated mab we getting a sharp peak but for our desired mab we are...
15 November 2020 7,359 0 View
I have attached an excel file with the quantification of a mineral I conducted EDS on. I have more excel files of minerals too as I know EDS spectra for only 1 sample will certainly not be...
03 November 2020 6,899 9 View
I performed a boc deprotection via 25% TFA/DCM (1 hr) without any workup, which should yield TFA salt as a product. My compound also had a TBDMS group on it. But when I took an NMR, the amine peak...
21 October 2020 4,470 3 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...
25 February 2021 9,602 4 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
Dear all, My research group is currently working with a 12-litre fermenter. Somehow, if we do the fermentation for more than 20 hours, the process will be more prone to contamination. Our current...
23 February 2021 1,908 2 View
Hello, I created a very tall tower (>1000m) and applied pressure boundary conditions at the inlet (bottom) and outlet (top) that correspond to the pressure are their relative altitudes....
22 February 2021 9,972 4 View
My team is designing a dual channel microfluidic chip that runs air and water. I think we've decided on the NE1000 syringe pump for it's versatility and feedback control. We will be ordering the...
18 February 2021 9,928 2 View
I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...
18 February 2021 1,450 3 View
How to find the air side pressure drop in a spiral fin cross flow heat exchanger? The pressure difference at the inlet and outlet is very low compared to the experimental results, which I...
18 February 2021 1,109 2 View
Knowing that the Venturi effect is used most in tubes (according to my basic knowledge in physics) to increase the speed of air or liquids by reducing the tube volume, my question is if we have...
17 February 2021 1,260 1 View
15 February 2021 1,997 6 View