Zherui Martinez-Guo

2 Questions 5 Answers 0 Followers

Questions related from Zherui Martinez-Guo

What causes contact penetration in the second material in this Abaqus simulation?

I have two materials, aluminum and steel, that I am simulating impact on. Both have the exact same material models: J-C plasticity and damage EOS Specific heat and inelastic heat fraction Damage...

14 June 2021 3,810 4 View

When using Abaqus JH1/JH2/JHB built-in VUMATs, what is the appropriate FS element deletion value?

I asked this a while ago, but decided to dig a little deeper before asking again. When using the Abaqus JH1/JH2/JHB Johnson-Holquist models for brittle materials, the FS (Failure strain) element...

12 May 2021 315 3 View