8 Questions 59 Answers 0 Followers
Questions related from Vladimir Dorofeev
I had to calculate parameters of the technical oil flow in Ansys CFX. To solve this problem, I used "the Turpentine" (from Standard Ansys CFX material library) as the working body. Is it right ? I...
09 August 2019 8,083 5 View
Is it possible to take into account connecting wire(fig.1) in the fluid flow calculation of a turbine stage in the Ansys CFX?
16 June 2019 1,100 4 View
I am calculating fluid domain with one inlet and two outlets (fig.1) I found that Ansys CFX unable to determine how much mass flow rate go to each outlet if i use boundary conditions: Total...
20 December 2018 3,546 10 View
I am trying calculate a steam turbine stage which works in wet steam zone. But i dont know how define boundary conditions: in Ansys CFX, because i can define only Temperature and...
24 October 2018 8,363 2 View
Right solve or not, if during all iterations Ansys CFX Solver manager writes, that he set up artifical wall on the outlet (in my case) ? Howewer, all residuals has attained the level required and...
19 August 2018 6,770 4 View
I'm trying to calculate valve of steam turbine in Ansys CFX (i'm using single phase material - water ideal gas).I'm getting that the mass flow rate in the inlet zone is not equal to the mass flow...
12 August 2018 7,550 10 View
I am trying to calculate flow of steam valve in Ansys CFX. Boundary conditions : at inlet - massflow rate and temperature of steam, at outlet - averaged pressure of steam; wall for all other faces...
07 August 2018 7,214 5 View
Good day. I am using AxSTREAM LITE v3.2.1. I am trying to calculate one stage axial turbine in existing analysis. In this calculation i need define manual deviation angle and manual blockage. To...
29 July 2018 3,435 3 View
