Srinivasagan Manickam

5 Questions 1 Answers 0 Followers

Questions related from Srinivasagan Manickam

How can I fix the contact-based meshing error for curved contact surfaces in the geometry model?

There is a geometric model configured with a set of coils wound over the inner core shaft. To ensure load transfer, "forced frictional sliding contacts" have been defined between the curved...

19 April 2025 4,439 0 View

How to make CAD model of bend configuration of flexible drive shaft?

I have to do kinematic analysis of flexible drive shaft with its bend configuration. I faced issues on modelling the flexible drive shaft which configured that the shaft having inner core wire and...

22 March 2025 3,390 2 View

Questions related to reducing heat generation and failure of flexible shaft?

In an experiment, a flexible shaft(stainless steel) of size 1.5 mm, is placed inside a 180 degree curved cylindrical conduit (a reinforced polymer tube of ID of 1.8 mm). The shaft is designed to...

06 March 2025 5,130 0 View

How is that results are varying in analysis software, from older version to newer version's?

If I run the same setup file in two different software versions, will there be a change in the number of elements and its mesh quality in the result?

24 February 2025 5,164 0 View

Questions related to stresses on thick cylindrical pressure vessel?

In a thick cylindrical pressure vessel, what are all the types of stresses acting on them? and tell that magnitude of various stresses acting on thick cylindrical pressure vessel in decreasing...

09 January 2021 7,591 0 View