Srimanish Reddy Enakonda

6 Questions 3 Answers 0 Followers

Questions related from Srimanish Reddy Enakonda

Can we brake precisely at a very lower rpm?

I am trying to test gear box endurance and efficiency of a modular small gearset in a test bench setup. I am struck finding a brake (i have tried magnet powder and hysteresis brakes online) for...

27 March 2025 6,472 2 View

Testing eccenteicity and angular misalignment of rotating hollow shafts ?

Hello Everyone, I am presently working on a hollow cylindrical shaft assembled in to another cylindrical shaft. The torque is transferred between these shafts through a one way sprag freewheel...

25 September 2023 8,933 0 View

Break away torque calculation of lock nut against rotating/acceleating bolts?

I have a Scenario where my lock nut is tightend using a prevailing torque of 14 Nm (as mentioned by the manufacturer) on to the rotor placed between bearings (But the tightening direction and the...

04 November 2019 4,350 3 View

FSI co-simulation of a revolute joint ?

Hello everyone, I have simulated a structural revolute joint which contains a bush revolving over the pin. When pretension applied, the pin creates about 290 Mpa contact pressure(CPRESS). Now, I...

31 July 2018 1,641 2 View

How to create an adjustable co-ordinate system in abaqus?

Hello all, I have created a solid shaft inside a solid shell and fixed the shell as a BC in the first step. In the second step, I have applied load on the surface of the solid shaft which...

18 January 2018 5,629 1 View

Is it possible to achive hydrodynamic surface interaction between pin and bush of a roller chain in Abaqus ?

When we design a revolute joint with the surfaces, the surface - surface interaction can be achieved in abaqus. But is it possible to achieve an hydrodynamic surface interaction between two...

19 October 2017 5,438 2 View