Shiv Sahaya Shukla

5 Questions 6 Answers 0 Followers

Questions related from Shiv Sahaya Shukla

What is the correct size of element to calculate T stress using CINT command in ANSYS APDL ?

I am trying to calculate the T stress from the ANSYS APDL 17.2 using CINT Command for a 2D plate under plane stress condition. The Code I am using is given below: CINT,NEW,1 CINT,TYPE,TSTRESS...

14 January 2022 2,765 0 View

How to calculate the T-stress in ANSYS for a cracked plate under plane stress condition?

I am trying to calculate the T stress for a mixed mode (I/II) problem using the interaction integral technique in ANSYS for a plane stress problem. But the T stress is not converging with the mesh...

03 September 2021 9,555 5 View

How to calculate the contour integral from orphan mesh in ABAQUS?

I have created a 2D cracked plate mesh in ANSYS APDL and then imported it into the ABAQUS. I want to calculate the J integral in ABAQUS using this mesh. I have followed all the steps as per normal...

03 September 2021 4,967 0 View

Which method for determination of stress intensity factor (SIFs) between (KCALC and J-integral ) gives better results for a three dimensional crack?

I am trying to simulate a three-dimensional crack geometry under mixed-mode (I/II/III) loading in ANSYS. I have calculated the SIFs along the crack front using both KCALC and J-integral...

27 February 2021 2,348 1 View

Can we get mode II SIFs (KII) for the pure mode I loading in 3D analysis of an edge cracked plate?

I am performing a 3D analysis of an edge cracked plate with a straight fronted crack under pure mode I loading in ANSYS APDL. And I am plotting the variation of SIFs along the crack front in the...

29 February 2020 5,940 2 View