7 Questions 5 Answers 0 Followers
Questions related from Sheik Yaseen Boodoo
Two nozzles of different output diameters (0.20 mm and 0.25 mm) are being used to take mass measurements for an analysis over a time period for the same input pressure. It has been observed that...
21 June 2018 5,705 9 View
The carotid shunt is made up of a tube on the extremities of which the balloons are glued during the manufacturing process. Quality control (functionality test) are carried out in order to ensure...
20 June 2018 6,794 3 View
Glue is discharged from a syringe tip at a constant pressure P through a constant time period t. The original tip is of diameter d1= 0.20 mm. A new tip is used of diameter d2 = 0.25...
30 April 2018 9,505 22 View
Two plastic tubing are to be connected and glued in perpendicular for fluid flow. Can you suggest any tests that can be done to detect any leakage at the joint? See attached photo.
27 November 2017 4,753 4 View
The hot plate is used for the thermoforming of components in a laboratory; max. temperature that can be measured : 500 degrees Celsius. Control tests are needed to follow up the equipment over...
16 November 2017 5,614 2 View
Waste heat recovery from the engine exhaust will be used to heat up fresh water up to 65°C. If heat exchanger is considered, which type of the latter is most suitable in this case?
25 February 2016 5,139 7 View
Hours of operation = 8,040 hrs/year Fuel used: Biogas I have come across an equation with regard to my question. However, I hope to get clarification from answers provided.
18 February 2016 1,803 7 View
