Shaik Kareemulla

3 Questions 2 Answers 0 Followers

Questions related from Shaik Kareemulla

Some higher order propagating modes at port 1 are not considered in time domain calculation.

Whenever i design uwb mimo antenna in CST, it comes up in error message "Some higher order propagating modes at port 1 are not considered in time domain calculation. This probablay leads to...

06 February 2017 534 5 View

Defined reference frequency for open boundary condition (9 GHz) is larger than the lowest relevant system frequency (monitor at 2 GHz).?

Actually i have designed uwb mimo antenna at the frequency range 3.1 to 10.6 GHz. but i have set the frequency range 3.1 to 16 GHz. but always the below mentioned message it will come while i am...

03 February 2017 4,563 3 View

After importing .dxf or .gbr file in ADS, how to simulate mimo antennas in ADS software?

Actually I have designed mimo antenna in cst microwave studio. After importing .dxf file in ADS software it contains only one single layer so how to make layout of this antenna. Please explain...

22 December 2014 413 9 View