Khawaja Muhammad Abdullah

4 Questions 2 Answers 0 Followers

Questions related from Khawaja Muhammad Abdullah

How y+ effect SST k-omega turbulence model, used to analyze slosh phenomenon in the tank?

I have simulated a tank subjected to harmonic excitation. I have used different turbulence model to simulate the same problem and validated the results with experimental data. The literature shows...

14 September 2022 6,453 0 View

I would like to know the significance of wall moment calculated using report force in fluent?

I am simulating a tank subjected to independent pitch and spin of equal magnitude. In case of spin wall moment is large as compared to that for pitching motion. Is there any physical significance...

23 August 2022 9,116 0 View

Is there any method to get wave elevation at a specific point in ANSYS fluent transient analysis?

I have used DPM to simulate free surface elevation by defining a mass-less particle at the free surface. I have recorded the z-component of the injection at different times. But the issue is these...

13 August 2022 8,995 0 View

I want to inquire about pressure surge occur in case of discontinuous frame motion while simulating sloshing phenomenon?

Hi, I am simulating a water tank subjected to discontinuous velocity (earthquake excitation). At the point of discontinuity a pressure surge is seen then it stablizes. I just want to know that is...

07 August 2022 9,809 0 View