Khaled Abdelgawad

4 Questions 10 Answers 0 Followers

Questions related from Khaled Abdelgawad

ABAQUS static analysis (Too many attempts made for this increment) error msg ?

am working on static analysis on abaqus where friction coeff. is defined to be 0.01 and everything is going on well ....... on replacing the friction coeff. from 0.01 to 0.3 the job is being...

11 October 2022 9,214 4 View

Is it applicable to estimate Young modulus of unknown material by obtaining the load-displacement curve from tensile machine ONLY ?

Some researchers referred to (Machine compliance factor) as indicated in the following link Using a Correction Factor to Remove Machine Compliance in a ... However, this technique is valid for...

16 October 2021 1,909 4 View

What strain gauge type suitable for measuring strain of steel until its fracture strain? ( i.e what strain gauge type can measure strain > 0.3)?

Stress-Strain curve for steel specimen need to be investigated

28 September 2021 704 6 View

Young modulus obtained from experimental stress - strain curve of steel is found to be around (8 GPa.) instead of (210 GPa.) .. Any suggestions ?

Tensile test parameters material : low carbon steel cross head speed : 1.8 mm/min ( approx. 2.67 MPa./sec)

05 September 2021 3,563 8 View