Hamid Reza Attar

8 Questions 14 Answers 0 Followers

Questions related from Hamid Reza Attar

How do I make Abaqus stop the simulation once a critical value of PEEQ has been reached?

Hello, I am doing a series of metal forming simulations in Abaqus. I want the simulations to automatically stop when a critical value of PEEQ (or some other variable) has been reached, in order...

02 February 2020 3,090 3 View

Why does increasing strain hardening exponent result in less material necking?

Hello, According to the power law, Stress=K*strain^n. Could someone please explain why an increase in strain hardening exponent n results in less material necking from this equation? Please see...

02 February 2020 1,996 4 View

How to use tie constraints in Abaqus to merge dissimilar meshes?

Hello, I am doing a metal forming simulation in Abaqus, and I want to create a mesh similar to the one in the attached image. Particularly, on the "Blank" part, where there is a dissimilar mesh...

02 February 2020 8,407 1 View

Why do I get different FE simulation results each time the solver is run?

Hello, i am performing a highly non linear metal forming simulation using PAMSTAMP FE simulation software. I have noticed that for the same mesh and boundary conditions, I get different results...

01 January 2020 3,336 4 View

How can I give an appropriate sign to equivalent plastic strain through thickness in a metal forming simulation in Abaqus?

Hello, I am doing a 2D metal forming simulation in Abaqus where I am forming a U-channel (image attached). I want to plot the change in equivalent plastic strain (PEEQ) along a path through the...

01 January 2020 1,427 4 View

How to ensure simulation calculation divisions on each core are the same for multiple runs?

Hello, I am running a finite element (FE) simulation using the FE software PAMSTAMP. I have noticed that when I run the solver in parallel with 4 cores, the repeatably of the results is poor;...

01 January 2020 4,473 3 View

What does the stress distribution in a plastically deforming structure actually tell you?

Hello, I am doing a non-linear metal forming FE analysis in Abaqus. I don't fully understand what the significance of the stress distribution (for example Mises contour) is, if the structure is...

01 January 2020 2,474 8 View

How can I show through thickness stresses along a non-linear bending path in Abaqus?

Hello, I am doing a non-linear beam bending / forming analysis in Abaqus. I want to to get results for the stresses through the thickness direction, where the top fibre will be in tension and the...

01 January 2020 1,735 9 View