3 Questions 12 Answers 0 Followers
Questions related from Abhishek Sharma
I have conducted a tensile test using a DIC setup. I have the data obtained from both UTM and DIC. I can predict the strain variation at any point over the entire test duration. However, I don't...
15 June 2021 1,093 3 View
What is plastic opening during lap shear deformation?
28 May 2019 4,266 0 View
In Al-5%CNT by powder metallurgy route.After ball milling(1hr,toulene) and compaction(200Mpa),the strength of green composite is too low. After ball milling and drying observed small lumps of...
21 December 2017 6,623 10 View
