Why used Unit Delay Block in LFSR to generated random bits ?

Sameer Hameed Abdulshaheed @Sameer_Abdulshaheed

03 March 2018 0 4K Report

We are used unit Delay instead (the Registers) in LFSR to generate random bits in Simulink.

Badges
Science topic

More Sameer Hameed Abdulshaheed's questions See All

Please , I need help, to know a fast and best publishing journal (Scopus) in computer Science or Engineering ?

publishing journal

07 August 2019 9,264 8 View

Logistical regression using SPSS for a dichotomous dependent variable, with an independent variable of 1, 2, 5 and 10 seconds?

I have an experiment with 28 participants The independent variable is the times 1, 2, 5, and 10 used as the cross hairs during a task These 4 times were tested using 4 different blocks, each...

03 March 2021 9,692 2 View

How could I process data in RCT to include it in meta-analysis?

I'm in the process of doing a meta-analysis and have encountered some problems with the RCT data. One of my outcom is muscle strength. In one study, I have three different measurements of muscle...

25 February 2021 7,603 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Is it mandatory to specify Subjects Combinations in Generalized Linear Mixed Models (SPSS)?

Hi all, I have data with two levels: lets think of the classic example of students and schools. When running the analysis in SPSS and selecting the Random Effects, we can select (we can or we...

24 February 2021 7,379 4 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How can I get "Matlab/Simulink model for Droop/Reverse Droop controllers"?

Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...

22 February 2021 8,647 2 View

ANCOVA controlling baseline in RCT - how to perform power analysis and sample size estimation?

Hi, I have a simple question. I am hoping to perform a power analysis/sample size estimation for an RCT. We will be controlling for baseline symptoms, and using post-treatment or change scores as...

19 February 2021 2,648 23 View

Why are the modelled and circuit system different in response for controlled buck converter?

[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...

16 February 2021 5,060 10 View

What will happen when we assume an upper bound of OFV lower than the global minimum OFV ?

if we assume 20 is the upper bound of an objective function (OF) based on permutation a square matrix (nxn) , The minimum value of the OF=22, then we run a random operator to compute the OF by...

14 February 2021 6,056 5 View

Pseudo random number generator in Matlab code ?

i want to implement pseudo random number generator in matlab ...i request to every one if someone have code these PRNG share with me SplitMix Permuted Congruential Generator (PCG) Random...

14 February 2021 6,828 7 View