Basically, the force supplied by a concrete compression machine is a definite value. For

normal concrete strength application, say below 50MPa, the stress produced by a

150mmx150mmx150mm cube is sufficient for the machine to crush the concrete sample.

However, if the designed concrete strength is 100MPa, under the same force (about

2,000kN) supplied by the machine, the stress under a 150mmx150mmx150mm cube is not

sufficient to crush the concrete cube. Therefore, 100mmx100mmx100mm concrete cubes

are used instead to increase the applied stress to crush the concrete cubes.

For normal concrete strength, the cube size of 150mmx150mmx150mm is already

sufficient for the crushing strength of the machine.

Thanks DR Amjad for this clarifying.