I used the Neural Network toolbox (nntool) from Mathwoks Matlab R2010b, on Windows 8.
After the network training process, when I try to simulate the network the program sends the error message “too much outputs arguments”. Can somebody help me?
hello, The problem was solved. 10x
Hi Daniel, i almost met the same problem in the nntool simulating process. Could u tell me how to solve this problem. Thx.
hello,
in my case it was a problem with size of the matrix (un-correlation between input / output)
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
Is there a powerful system for the security of the systems distributed on IoT systems?
02 March 2021 3,858 10 View
Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...
01 March 2021 2,327 1 View
Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...
01 March 2021 6,200 3 View
The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...
28 February 2021 6,560 14 View
I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...
28 February 2021 3,459 3 View
Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...
25 February 2021 3,443 4 View
I am working on creating deep neural network on geospatial dataset and wanted to know how to do the sampling so that I can increase the presence of solar panels in the images. I cannot use entire...
25 February 2021 3,936 6 View
I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...
25 February 2021 5,435 2 View
I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?
24 February 2021 5,602 2 View