What is the method to convert a batch reactor to continuous mode?

More Aynaz Biuky's questions See All

With what device can the electrostatics of powder particles be measured?

Please shar refences

13 January 2024 2,586 2 View

What is the formula of viscosity of non-newtonian fluid?

Is the formula for calculating the viscosity of non-Newtonian fluids the same as Newtonian fluids?

16 December 2023 2,837 12 View

How can I calculated heat transfer coefficients?

آHello all dear What reference should I use to calculate the heat transfer coefficients of plate exchangers that has step-by-step solutions?

19 November 2023 8,133 5 View

How convert vacuum distillation from batch to continues?

How can I do calculations and scale up? Can you send me some references ? Thanks in advance

15 November 2023 4,864 7 View

What is the method of scale-up for convert a batch reactor to continues?

Thanks in advance

14 November 2023 6,857 7 View

How to change batch to continues mode and scale up?

Hello all dear If you know any reference or website about this subject, please share it with me Thanks in advance

08 November 2023 3,272 4 View

How to calculate the fluid velocity in the exchanger without knowing surface area of the exchanger?

It's a tube & shell exchanger

29 October 2023 10,019 17 View

How to calculate the enthalpy of vaporization of the compound?

Hello all dear It happens at a constant temperature of 140(Tb) The composition is similar to gasoline Can you introduce an equation? Thanks in advance

18 October 2023 9,317 4 View

How to calculate the cp inverse of the temperature for Q=cpdT formula?

I have two values of cp at 100 and 140 degrees

16 October 2023 1,860 10 View

What are the different ways to calculate enthalpy of vaporization?

Hello all dear A solvent enters a vessel at a temperature of 100 °C and turns into solvent vapor at a temperature of 150 °C. I want to know if this analysis I am doing is correct? The 100 °C...

15 October 2023 5,236 16 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Can we patent a process flow diagram developed using a process simulator but no actual cases is carried out?

Can we patent a process flow diagram developed using a process simulator but no actual cases is carried out? For example consider a process for certain product manufacture where a new process flow...

31 July 2024 781 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can you recommend provider Intermediate laboratory test for hydrocarbon, polyethylene & polypropylene?

Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...

25 July 2024 8,108 0 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View

Alex Gautier Tsopgo

Hello,

For different reactions, different types of continuous reactors are required, so there are several methods to convert a batch reactor to continuous mode.

Here are some references:

https://www.manufacturingchemist.com/news/article_page/Turn_batch_to_continuous_processing/54954

https://assets.new.siemens.com/siemens/assets/api/uuid:b90c1a20-67be-430f-9c39-d00488593d33/210-batch-to-conti-improved-selectivity.pdf

http://www.controlglobal.com/articles/2009/Batch0909/

Aynaz Biuky

Thank you so much Dr. Alex Gautier Tsopgo

You are welcome Aynaz Biuky