What is the maximum % elongation expected from 3mm thick, hot rolled AISI304 plates?

More Arshad Noor Siddiquee's questions See All

Help witb ultrasonic machining head

I am interested in procuring an Ultrasonic Machining Assistant of about 1 kW power and 30-35kHz Frequency. Can anyone provide me an information about any indian supplier/ manufacturer of this system??

07 August 2013 4,737 5 View

What is the maximum % elongation expected from hot rolled AISI304 stainless steel?

Can anyone advise or recommend literature? Hot rolled AISI304 stainless steel.

07 August 2012 4,657 6 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Can you recommend provider Intermediate laboratory test for hydrocarbon, polyethylene & polypropylene?

Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...

25 July 2024 8,108 0 View

Can we eliminate the stress singularity at the tip of the crack by manipulating the elastic constants?

The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.

25 July 2024 9,976 3 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Why do fish have fishy odors naturally ?

Chemical Engineering /Food Engineering

20 July 2024 4,152 4 View

Pandu Kaviti

Go through on hot rolled steel plant books.....

Kishan Chand Gupta

Please refer Hand book on it.

Arshad Noor Siddiquee

Thank you Mr. Pandu and Mr Kishen

Ali Salehi

Tensile strength (N/mm2Mpa): 520=205

Elongation δ5 (%): >=40

Hardness: HB

Thanks Mr Ali for your response. But the properties specially yield strength and elongation of AISI-304 considerably depend upon the history of prior proceesing