Any paper or report about the actual efficiency during the recycling of polymers (ABS, PLA, PP, PE...). I understand it is impossible to recycle these materials without incur in material loses.
Topic: Additive manufacturing lifecycle
Dear Jaime,
there seem to be at least 2 publications on this topic:
Article Mechanical Properties of Specimens 3D Printed with Virgin an...
Conference Paper About the Use of Recycled or Biodegradable Filaments for Sus...
Kind regards
Felix
I need to identify examples of Open Architecture Products. I have some from Koren et al. 2013; however is not easy to find additional examples.
09 October 2017 5,012 1 View
I am working on the development of sustainability indicators for open architecture products taking into account the strategies of circular economy.
08 September 2017 4,198 7 View
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
We intend to study the interaction between peptides and polymer (like PP, PE and PS) through MD simulations using Martini force fields ( Martini 2 for PP and Martini 3 for PE, PS). We have...
08 August 2024 4,842 0 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?
04 August 2024 1,078 1 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.
29 July 2024 6,350 3 View
If the pairs are similar, will it reduce the adhesion due to electric charges?
29 July 2024 3,185 2 View
After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?
29 July 2024 4,955 0 View
Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...
28 July 2024 6,553 1 View