When I am try to analyse a program in UDEC, it shows the error of
Rounding length too great. Rounding length is too high for edge size. Either reduce rounding length or increase the edge length.
What is the problem if rounding length becomes high ???
Dear Malavika Varma,
Look the links, please.
http://www.nrc.gov/docs/ML0331/ML033160532.pdf
http://upcommons.upc.edu/bitstream/handle/2117/78120/TFC_Guillem_Miro_20_05.pdf
Regards, Shafagat
Thank you Prof. Shafagat...
The manual states "The rounding length, if kept small (typically around a few percent of the average edge length), has no practical influence on the results of the analysis".
We assign the round length small. But why is it having no influence? And what makes the results wrong as round length becomes high?
It also fails to provide the detail on why a rounding length large for triangular zones are fine and works with quadilateral zones.
Warm Regards
Malavika
- Badges
- Science topic
- Similar topics
- Computer Science
- Program