Hi, I want to connect UHF RFID reader (902~928mhz Frequency; RS 232 (model)) to Raspberry Pi 3. I have attached the link to the brought model (https://www.amazon.com/reader-vehicle-parking-application-meters/dp/B018EFLJJI).
I am new to python, recently took the above RFID model, fortunately, I could not able to get the information on the sample table for calculation of entry time and exit time of the tags. The information given by the supplier was not helpful. His software has very limited information such as a tag number, number of time entry (counts) without any time interval.
The only software can help me out is Raspberry Pi 3, but I am not very good with coding. Can you please help me!
What I need from you is: If there is any tag near to RFID reader (maximum) 6 meters, accept the signal and note the timing, tag number, and the date. Thank you😊
Your amazon kit allows RS232 communcation.
You could use the RPi 232 port on GPIO.
There some lib in python to use easily serial port like pyserial.
- Badges
- Science topic
- Similar topics
- Computer Science and Engineering
- Programming Languages
- Python