Is there any method to engineer liposome that denatures in the presence of specific light trigger.
Dear Researchers, I came across an article (journal name of which I do not wanna mention at least for time being, it has an impact factor of 5) which was in line with my research interest and in...
03 April 2018 239 1 View
Curcumin we can measure in UV, but how can we measure the amount of cyclodextrin preset in the complex? In the following paper it has mentioned in 2.3 Formulation of the cyclodextrin complex of...
04 May 2013 5,151 4 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,489 1 View
I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...
05 August 2024 3,289 1 View
I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....
31 July 2024 3,842 7 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,713 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,225 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 646 3 View
// interested in the difference between floating events and short circuits.
22 July 2024 6,565 0 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,488 2 View
I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...
21 July 2024 1,558 1 View