Parameters and fabrication of micro lens array?

11 November 2016 0 7K Report

Is the size of the unit lens of the micro lens array to be equal to or close to the focal length (or radius)? If it can be achieved, which manufacturers can make? Thanks.

Badges
Science topic

Similar topics
Econ
Manufacturing

How Do Length of Pylon and Rotor Disk Radius Impact Angular Frequency and Torsional Stiffness in Whirl Flutter Analysis for a 2 DOF Propeller System?

Actually, I'm having trouble implementing the plot of the flutter region for the whirl prop system with 2 DOF (Influences of structural damping and propeller—pivot point distance on whirl flutter...

21 July 2024 5,047 2 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

How to classify 3D Bioprinting as a part of Additive Manufacturing?

Hello, I have a problem in classification of "Additive Manufacturing" techniques. There are several classification for Additive Manufacturing e.g. Powder, Extrusion, Resin etc. Actually, I am OK...

15 July 2024 139 3 View

How to get discharge capacity of a bole well?

No data regarding radius of influence is provided and no pumping test data available.

10 July 2024 7,168 0 View

How can I find the absolute maximum value of the Lamb-Oseen vortex with a no-slip condition?

R(t) = the propagation function of the vortex, where R=sqrt(4vt + R0^2) R0 = initial radius. w0 = initial angular velocity. Rf = the radius of the boundary confining the fluid. The Lamb-Oseen...

07 July 2024 3,680 0 View

I need Agile topic for my PHD ? any recommendation ( Safe) ?

Hello All, it has been a while searching for a good topic to Agile, and also i need topic that can do a real impact in agile field? any recomendation ?

07 July 2024 8,450 3 View

What role does grain size play in the mechanical properties of nanocrystalline metals and how can this be controlled during the manufacturing process?

In nanocrystalline metals, the size of their crystalline grains affects how strong, ductile, and hard they are. Smaller grains often mean stronger metals but can reduce ductility. Controlling...

28 June 2024 6,925 0 View

Is it possible to customize the acoustic lens of the ultrasonic transducer in Field II?

We are interested in studying the effects of varying lens curvatures and material properties on the acoustic field. If this is not feasible, could you recommend alternative software that allows...

15 June 2024 6,213 0 View

Which solvent and substrate is found to be best suited for deposition of electrodes with MXene ink?

Suppose we have dried MXene slurry (Ti3C2Tx), then the combination of which solvent (in which this dried MXene slurry powder will be mixed, subsequently forming the "ink") and corresponding...

13 June 2024 5,763 0 View

ImageJ Concentric Circles?

Hi there! We are trying to use the Concentric Circles Plugin on ImageJ to determine signal intensity in neurosphere cryosections after immunocytochemistry/confocal analysis. We determined the...

12 June 2024 7,332 0 View