Modeling of Gas Insulated Substation ?

More Jayadhar Kona's questions See All

What is/are the main course of staff turnover? How to identify a specific challenges or opportunities related to HR or organisational Development?

The project requires to select a real organisation and conduct a comprehensive analysis of the HR practices and organisational development strategies. Provide a detailed proposal outlining staff...

28 April 2024 9,910 7 View

What is the constitutive law used for powder bed particles interaction?

I am modeling a powder bed by using finite element method, In the mechanical behavior of the the powder particles depend on the friction between the particles and the sliding movent with blade.

11 October 2023 4,071 1 View

How can we develop crystallization process?

Development relation with Solubility Curves, Supersaturation and the Metastable Zone Width (MSZW)

08 October 2023 4,752 0 View

How to formulate the Navier- stokes equation for both fluids and solids?

I am modeling the phase change material in FEM, initially the material is solid state,and the heat supplied by laser scan on the top surface, due this heat source of the model get transform form...

11 September 2023 4,193 2 View

Why equivalent Von Mises stress used to find out the residual stresses in the body?

I am trying to model the residual stress in the body, which is subjected high temperature gradients. In the process of cooling/solidification the residual stresses are formed in the member. I red...

06 September 2023 6,483 2 View

Please answer this error in comsol ?

The following feature has encountered a problem: - Feature: Dependent Variables 1 (sol1/v1)Solution 1 (sol1) is not computed

29 May 2023 781 1 View

How can we manufacture the inactivated polio vaccine?

I want a clear idea about it with specific name of antigen generation.

24 May 2023 3,129 1 View

How to model the selective laser melting (SLM) in COMSOL?

Basically, I am trying to model the material powder bed to solidification of the metal in comsol. please explain the developing steps.

23 March 2023 8,658 4 View

What will be growth rate of BL21(DE3) with and without PET Vector plasmid in M9 media?

Without Induction i would like to know what will be growth rate in PET vector if transformed in BL21(DE3) ...By addition of 30mg/lit of Kanamycin in M9 media what will be relative effect ...Any...

03 July 2021 4,550 1 View

Hot to convert a Boc protected Amino Acid carboxylic acid to ester hydrochloride?

What are the by products when a Boc protected Amino Acid carboxylic acid reacts with an alcohol in presence of thionyl chloride to produce an ester hydrochloride salt? How does the N-Boc is broken...

30 October 2020 6,153 5 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

Robert Ziemba

This article may be helpful for you.

http://www.meps10.pwr.wroc.pl/submission/data/papers/13.4.pdf

Regards,

Robert

Tahir Midhat Lazimov

http://pe.org.pl/articles/2012/4a/73.pdf

http://ieeexplore.ieee.org/xpl/login.jsp?tp=&arnumber=160586&url=http%3A%2F%2Fieeexplore.ieee.org%2Fxpls%2Fabs_all.jsp%3Farnumber%3D160586

Srete Nikolovski

As I can see in above papers I can also recommend you free ATP/EMTP software.

Srete