Hello all
I want to make interatomic potential for aluminum for radiation damage but couldn't find parameters (like shown below in attachment) in literature as much as i studied. so if anyone could help.
Thank in advance.
I need eam inter-atomic potential for HCP Zr-Nb. Any recommendations where i can get or if anyone have.
09 October 2017 4,143 1 View
I want to perform LAMMPS simulation to find the effect of temperature on defects created in material when doing cascade propagation. If anybody can please share any LAMMPS input file for this...
31 December 2015 9,554 4 View
We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...
03 March 2021 7,975 3 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
We are preparing some experiments based on irradiating cells under different conditions in order to evaluate the effects in terms of DNA damage, genetic expression, etc. As our project is...
01 March 2021 3,355 3 View
I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...
28 February 2021 5,415 1 View
Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...
27 February 2021 5,028 2 View
I am wanting to run a serial mediation model with 2 x IVs, 2 x MVs, and 3 DPs (all continuous). Is it problematic to run 2 different models for each IV, keeping the MVs and DPs the same in each...
27 February 2021 5,681 3 View
Hi, all! I need to determine if my treatment causes membrane damage in bacteria (S. aureus and E. cloacae), but I cannot use a fluorescent probe such as PI and similar ones because my compound is...
24 February 2021 2,006 2 View
It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...
24 February 2021 5,974 4 View
24 February 2021 1,005 1 View
Are there any references to insects or animals that can cause damage or weathering to the rock or fossil material? books or paper that would be nice. Thank you very much!
24 February 2021 6,805 3 View