Are there any relevant speicifications?
Can I model a diaphragm as multiple master-slave node, lines of code or should I specify the whole polygonal boundary at once?
11 December 2017 602 6 View
When conducting finite element analysis according to the Eurocodes, is it sufficient to use the uncracked moment of inertia, or is there any notion for the effective moment of inertia alike the...
10 November 2017 5,262 6 View
I am searching for a detailed solved example of a shear wall that also have to resist an axial load (design should be compliant to Eurocodes).
10 November 2017 504 4 View
I am trying to find through which combination of commands, I check if a particular cross section, has sufficient capacity or not, after the structural analysis. The structural analysis will...
10 November 2017 5,470 4 View
Especially if it is combined with workshops.
09 October 2017 532 1 View
E.g. fixed end moments, shear forces, etc.
09 October 2017 2,055 4 View
Would the modeling of a physical system that displays a dynamic behavior be benefited by the use of e.g. genetic algorithms in order for optimal temporal decisions to be determined?
09 October 2017 4,959 3 View
loads{k,1}=loads{k-1,1}+1; loads{k,2}='py';
09 October 2017 3,177 3 View
Is there any relevant theory and publications?
09 October 2017 6,155 3 View
E.g. tables etc.
09 October 2017 8,099 3 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,492 1 View
We have observed that tube to tube sheet joint leaked in our boiler and needs to overcome same by knowing the root cause.
08 August 2024 3,161 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 453 3 View
Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...
04 August 2024 8,997 1 View
I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...
03 August 2024 6,028 4 View
Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...
03 August 2024 2,545 2 View
Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...
31 July 2024 3,913 6 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,226 2 View