I need help in wavenet matlab code, any one help me?

More Muhamad Azhar's questions See All

How can I write a small research article?

I am an undergraduate student of electrical engineering. I want to write an article on any topic related to electrical engineering, environment or both. But I do not know how to write it. I know...

24 December 2020 9,636 4 View

. Any one can help me to write the slantlet matlab code?

I tried to use Slantlet transform for fault diagnosis

06 December 2020 4,987 2 View

I am looking for Optimal design of Euler Bernoulli cantilever column, with analytical or semi-analytical solution?

I need guidance on the analytical model and calculation for shape (cross-section) optimization of Euler Bernoulli cantilever column under buckling with a point load. It may be using variational...

05 December 2020 9,133 5 View

How to simulate force transmissibility in ANSYS?

I've been trying to simulate the force transmissibility experiment based on the setup shown in the attached diagram where the transmissibility is defined as the ratio of transmitted force...

14 October 2020 9,141 2 View

Is there any effect of graphene oxide in ionic liquid?

I tried to mix polyurethane and graphene oxide with ionic liquid (EMIM-TFSI) to enhance it's ionic conductivity, will there be any effect in functional group charge (negative -cooh, -oh) of GO or...

27 May 2020 7,333 4 View

What is your opinion about virulence factors corona 19 virus?

many virulence factors that own in microbes which one in corona 19

16 April 2020 5,892 9 View

Why modal analysis and harmonic response natural frequencies not equal ?

Hi, anyone can help me with this problem I encountered? Brief explanation on my research. So I have this cubic sample made of ABS material formed into specific structure/configuration. I want to...

11 September 2019 9,208 2 View

I want to ask you a question related extraction of plasmid (PET28a)?

I tried many times for the extraction of plasmid(PET28a vector) . The concentration is very high. But the problem is after running Gel electrophoresis i get 3 bands as you see the attached...

15 January 2019 9,920 3 View

XRD of TiAlN/Cu Multilayers?

One of our friend has done XRD of his thin multilayered samples coated on Si. The layers are TiAlN with two different coatings of Cu on it. There is one strong peak at about 69, which we think is...

09 October 2018 5,030 7 View

Density of states for 3D/2D perovskites?

Do we have a number for DOS (Nv, Nc) for 3D or 2D perovskites? Although I see few papers reporting DOS, I do not find a number. Or maybe I do not find a way to calculate DOS from the plots.

25 July 2018 8,577 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What program can I use to caclulate dipole moment efficiently and without the need of excessive computation?

Hi, I am a third year chemistry undergrad doing my group project in which I need to predict the HPLC retention time of 20 aromatic molecules. to do this we require the chemical properties of these...

24 February 2021 1,384 3 View

In frequency domain alpha band(8-16hz), beta band(16-32hz), gamma band(32-64hz), sub-band(64-128hz) are same as LL,LH,HL,HH in wavelet decomposition?

I am working on single trial motor imagery data i.e. EEG data. I am following a paper which has a dataset from BCI challenge IV (dataset 2b). After removing noise and extracting all the data from...

23 February 2021 5,503 1 View

Ali Hasan Ali Popular answer

Could you explain what you exactly need in details? I might be able to help you with that.

Shanmuga Sundaram

sir share your work flow

Bazhdar Noureddin Mohammed

do you mean Wavelet Neural Network (WNN)?

Ali Hasan Ali

Muhamad Azhar

I want to use the MLP with maxican hat T.F to be modified with wavelet and finally obtain WNN and use it for the purpose of classification