An error occurred while running the simulation and the simulation was terminatedCaused by:
- Derivative of state '1' in block 'dof/Integrator6' at time 0.0058699478580727573 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
Alexander Pugachev
You can read this conversations. It concerns the same matter.
Regards.
https://www.researchgate.net/post/How_can_I_can_correct_an_integrator_error_under_MATLAB_Simulink
0 votes
0 thanks
Abid E. Mansuri
hii
you can check your simulation carefully
your input value of integrator is negative value
"integrator dont takes negative value"
you can check your simulation and solve it & give the integrator value positive
then you can give positive value of integrator your problem is solved.
thank you...
0 votes
0 thanks
Kheireddine Choutri
You're facing a singularity, you need to adapt the time step or change it to variable time step.
Good luck
0 votes
0 thanks
- Badges
- Science topic
Similar questions and discussions