Hi,
I want to run a stepper motor without using the software which is provided with the stepper motor vendors.
I want to send signal/command (Using Matlab) of the same format as it is send by the vendor software.
can anyone please suggest me.
yo need to tcp/ip tower of protocol and it is a software solution. It is possible to use a microcontroller. lwIP it is an open source implementation of tcp/ip tower that works with microcontrollers
You can perform remote debugging of your system with System Console. Debug equipment deployed in
the field through an existing TCP/IP connection. Run a network stack on either a Nios II processor or a
hard processor system (HPS) and piggyback on an existing remote administration setup. This application
note focuses on the case of using an Altera SoC.
https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature/an/an_693.pdf
- Badges
- Science topic