I am working on fish feed pellets and I want to test its durability....
Thank you so much Nirmala S.V.S.G
it was helpful for me
I tried liquid evaporation under vacuum, at 50, 60 and 70 degrees C and respective vacuum pressures 165 mbar, 250 mbar and 395 mbar respectively. But I found water evaporate at faster rate in case...
02 March 2019 2,054 1 View
I want to develop calibration curves for sugar analysis
03 April 2018 866 2 View
31 December 2016 3,429 0 View
Can some body help me to find through standard method. reference ? I tried 105 deg. C but all the material melted. AOAC-2000 not worked
01 January 1970 3,277 5 View
I want to analyses the proportion of swimming sperm of three species of fish in two salinities. To analyse the proportion of swimming sperm in a Generalized Linear Model, I would use a Binary...
03 March 2021 2,297 3 View
I have designed reflectarray element to generate OAM beams at 5.8GHz and feeding it though Horn Antenna on HFSS. After full wave simulation, i am not getting desired results i.e Radiation pattern...
01 March 2021 9,701 5 View
I am aiming to determine the ADC values of a commercial fish feed, but I do not have a steam pelleter or extruder available to me. Ideally, the pellets could be coated with some inert marker....
28 February 2021 7,967 3 View
Literatures on the piscicidal effect of sennaa alata is scanty. if you have any related litrature either in the bark, leaves or roots used as treatment to any aquatic organism please kindly help...
28 February 2021 9,138 2 View
Hello everybody, I am investigating the influence of a toxinon various clinical-chemical and haematological parameters in fish. I have three treatments (control, low dose, high dose) in my...
24 February 2021 1,243 1 View
if we expose the fish after acclimatization to particular toxin in order to find out LC 50 (96 hours).Should we keep the fish off feed or with feed for that duration. Some literature show that...
24 February 2021 357 2 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
I am doing a proposal for a research entitled 'GRAIN YIELD AND QUALITY RESPONSES OF WHEAT GENOTYPES UNDER CO2 ENRICHMENT AND EXTREME EVENTS' I will be using climate chamber and I would like to...
18 February 2021 6,494 4 View
Dear all, I have harvested fibroblast cells from R26p-Fucci2 mouse embryos (mouse line as described in this paper: https://dev.biologists.org/content/140/1/237) and cultured them on plastic,...
17 February 2021 3,368 2 View
Hi Dear All, I prepared the extract of fish larvae whole body with PBS. Then protein concentration of the whole-body extraction samples determined by the Folin-Ceiocalteu-Phenol method (Lowry...
17 February 2021 1,971 3 View