Hello everyone, Hope all the researcher out there is fine. I'm having three error message during simulation of microstrip patch antenna simulation:
1. Computing Solver Domains, process hf3d error: Error in using BI boundary or IE region: this boundary (Rad1) has to touch background on one side.
2. Error in splitting meshes for domains.
3. Simulation completed with execution error on server: Local Machine.
Can anybody help me? Thanks in advance.
Dear Hoque,
Try to create Open Region Boundary using the following steps,
1. Right-click anywhere in the modeler window and select Create Open Region from the
short-cut menu.
Note: Observe the operating frequency is the same as the adaptive frequency of ( Fc GHz).
Since you already defined the solution frequency in the Analysis setup, Create Open Region
automatically defines the Operating Frequency with the same adaptive frequency, in this
case, (Fc GHz).
2. Ensure Boundary is set to Radiation and click OK as shown in the attached figure.
- Badges
- Science topic
- Similar topics
- Computer Science
- Computing