In the name of God
Would the method have acceptable aspect ratio at micrometer scale?
Thanks Guys
Hello Joachim Pimiskern
It was about Laser-Assisted Direct Imprint (LADI), not my question.
Anyway, thanks for the answer.
yes. imprint based methods can easily do micrometer scale structures. What is the aspect ratio you are looking at?
In the name of God Hello Small labs all over the world need a cheap tool for prototyping nano structures; Is Nanoimprint really the case? Can it stand on its foot? Will nanoimprint lithography...
31 December 2011 8,959 0 View
In the name of Allah Hello suppose all philosophers are sitting down in front of you. and each of them is stating something. form where he takes his or her statement? On what basis we should...
31 December 2011 5,473 65 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 648 3 View
// interested in the difference between floating events and short circuits.
22 July 2024 6,565 0 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
Chemical Engineering /Food Engineering
20 July 2024 4,152 4 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I want to reduce simulation time in CST for frequency domain solver by upgrading my computer. I already have discrete GPU but it doesn't seem to make any difference at all compared to integreted...
10 July 2024 2,789 4 View